View Single Post
Unread 02-18-2005, 12:12 PM   #1
the jew (raven)
Cooling Neophyte
 
the jew (raven)'s Avatar
 
Join Date: Nov 2003
Location: Where hockey pucks fly free
Posts: 12
Default Danner Mag 12 vs. MCP650

Ok, after going through Cathar's pump thread (again), I've arrived at a bit of a dilema. I have a Danner Magdrive 12 that I had used for an aquarium setup. Here are it's specs:

Mag Drive #12 Flow (gph) 1200 1150 1100 910 700 600 15' 110
taken from:
http://www.aquatictech.com/pumps.html


After reading a review on the MCP650, it was suggested that it would be fine for a dual CPU setup (which is what I have). So, basically, I'm wondering if a single MCP650 would be adequate in this system:


pump-->rad#1-->rad#2-->cpu#1-->cpu#2-->chipset-->gpu-->pump


Specs on hardware:

2 X dual 120mm heatercores from DD
2 X MCW6002-PX on 2 Xeon's clocked over 3gig
1 X DD i875 chipset block
1 X MCW50 on a 6800GT


Thoughts? I realize it would be ideal to have 2 MCP650's, but I don't have that kind of money right now. Thus, I'm asking if a single MCP650 would do or if I should just keep the Danner. Thanks.
the jew (raven) is offline   Reply With Quote