View Single Post
Unread 02-21-2005, 05:57 PM   #1
Gulp35
Cooling Savant
 
Gulp35's Avatar
 
Join Date: Sep 2002
Location: Atlanta, GA
Posts: 135
Danner 3 Pump Broke :(

As many know, my W/c loop was filled with some nasty looking crap.... I just put in distilled ...So last weekend I was planning on cleaning it out with the Airspirit *sol Flush. Hoping to weaken some of the junk before the weekend cleaning, I poured a little bit into my system. Less than 48 hours later I found a crack in the inlet on the inlet manifold on my Danner Mag 3. I had been running this system, gunk and all, for about 4.5 months, and I believe that the Pinesol somehow caused my pump to crack. I'm not 100% sure of this but right now it seems to be the only thing I can blame (besides my neglegence and procrastination).

It was a good thing (as matha likes to say) however, because I found that I really needed to clean out my system. My Cascade is Black inside, including the plastic, and all of the nylon barbs were coated/stained with a brown residue. Near spring cleaning was well due.

Anyone have any suggestions? comments? scathing critisisms?

What would turn the cascade black, was it the algae or was I having some corrosion going on (I have no aluminum that I know of, and I am pretty sure my HC is all/mostly copper (and brass))?

In the Future what should I use to clean my system if Pinesol id cause the pump trouble?
__________________
Epox 8RDA+ v1.1----------Tyan K8SDPro
1700+ JUIHB 0310XPMW (12.5x200Mhz@1.792v)--------2xOpteron246 (2Ghz 1MB L2)
2x256MB Kingston PC3000 (BH5?) 2-2-2-8 2.7v---2x512MB Corsair Reg.&ECC PC3200
ATi Radeon 9800Pro (stock, too hot)-----ATI RageXL
WD800JB+WD2500JB-------WD1600JD
Sony DVD/CDRW-------NEC 3520A Black
Forton350W--------Antec TruePower2.0 550W EPS12v

Last edited by Gulp35; 02-21-2005 at 09:17 PM.
Gulp35 is offline   Reply With Quote