Pro/Forums - View Single Post

Ruiner · 02-22-2005, 10:06 AM

Are there mobos that are a problem and others that aren't?

I was planning on popping the IHS almost immediately after I went K8. Hoot's solution of sanding the cam lock works, but sounds at least a bit risky.
If certain boards had flatter cam locks, it would affect my choice.

I suppose I would downsize to 7/16" tubing in any case, given the 1-axis design of the k8 retention system and the potential torque of the 1/2" ID I'm using now.

02-22-2005, 10:06 AM	#4
Ruiner Cooling Savant Join Date: May 2003 Location: New Smyrna, FL Posts: 258	Are there mobos that are a problem and others that aren't? I was planning on popping the IHS almost immediately after I went K8. Hoot's solution of sanding the cam lock works, but sounds at least a bit risky. If certain boards had flatter cam locks, it would affect my choice. I suppose I would downsize to 7/16" tubing in any case, given the 1-axis design of the k8 retention system and the potential torque of the 1/2" ID I'm using now.