Woof Woof!
My current block with 61) 1.65mm ID nozzles (3/32" tubing) does not cool as well as my WhiteWater clone. Now I see why. Thanks guys. To avoid major rework, I'm going to try sliding smaller telescoping nozzles with an ID of .87mm (1/16" tubing) inside each one and retest. This will be a compromised effort from the start since the smaller tubing has an OD of 1.575mm and slide freely inside the larger tubing. They will drop down and rest against the bottom of the cups, but I'm guessing that the water pressure may lift them slightly to allow it to escape. "Hydraulic Lifters"
My results will be over on the
original thread
I'm a hack, but I love playing in the mistique of not doing the math. Just gut feeling.
Hoot