Water finally set up - Frothy Water?
Water setup - Water is all frothy?
Hey i just finished setting up my final water cooling system. I did a test run a while back, but i didn't use water wetter. Now this is my final setup, so I did use WW, about 2 oz per gallon. Now the water is super duper frothy, and it runs through the tubes and all that.
Since I am using silicone hose, I can't really see what is going on in the tubes. I use a 10oz dubro, so I look in there, and it is frothy. Any Ideas? Does it go away with time? Only been on about 1 hour, so I guess I will wait till tomorrow. Maybe my flow is too fast, or dubro too small?
Also, I cracked the acrylic top off my spir@l, so luckily I had a spare maze2 laying around. I was pissed though, hopefully danny or fixitt can sell me a new one. I swear something is keeping me from using this spir@l, tons of incidents, one after the other. After I get it all new and spiffy I just might sell it, anyway, i'm going to start a new thread to rant about it.
deez
|