Pro/Forums - View Single Post - Power sloution for two 172W pletiers for less than $200??

resago · 01-08-2002, 09:36 AM

hmm, I had considered just on the waterblock, I hadn't though about a pelt failure, I was thinking pump failure. the relays would protect against pelt PS failure.

would what the relation of temp be between block and cold plate if a pelt failed. though it will be protected somewhat since each block will be running 2 pelts.

Must think some more.

the dual pelts should provide enough protection if one should fail, I would notice the problem by the fact that the CPU is no longer running below 0C. Not catastrophic by any means

anyone have any thoughts?

01-08-2002, 09:36 AM	#89
resago Cooling Savant Join Date: Mar 2001 Location: state of denial Posts: 488	hmm, I had considered just on the waterblock, I hadn't though about a pelt failure, I was thinking pump failure. the relays would protect against pelt PS failure. would what the relation of temp be between block and cold plate if a pelt failed. though it will be protected somewhat since each block will be running 2 pelts. Must think some more. the dual pelts should provide enough protection if one should fail, I would notice the problem by the fact that the CPU is no longer running below 0C. Not catastrophic by any means anyone have any thoughts? Last edited by resago; 01-08-2002 at 09:40 AM.