Pro/Forums - View Single Post

HaloJones · 03-03-2005, 07:16 AM

Being incredibly stupid, when re-building my system after a flush, I pushed the inlet fitting on so that the shaft was not properly in the little hole and then turned on the pump. It didn't spin properly of course. After taking it apart again and putting it back together properly, it still won't spin up.

Have I burnt out the motor? Do I need a new shaft?

Any ideas?

03-03-2005, 07:16 AM	#1
HaloJones Cooling Neophyte Join Date: Sep 2003 Location: Moab Posts: 45	Eheim 1250 Problem Being incredibly stupid, when re-building my system after a flush, I pushed the inlet fitting on so that the shaft was not properly in the little hole and then turned on the pump. It didn't spin properly of course. After taking it apart again and putting it back together properly, it still won't spin up. Have I burnt out the motor? Do I need a new shaft? Any ideas?