Quote:
|
Originally Posted by HaloJones
Being incredibly stupid, when re-building my system after a flush, I pushed the inlet fitting on so that the shaft was not properly in the little hole and then turned on the pump. It didn't spin properly of course. After taking it apart again and putting it back together properly, it still won't spin up.
Have I burnt out the motor? Do I need a new shaft?
Any ideas?
|
Doubt you burned anything up. That may even be impossible.
Reevaluate your assembly. Possibly reference an exploded view or parts diagram.
Is the shaft bent? Will the rotor spin freely on it?
I have an unused 1048 at work and I will look at it Monday to make suggestions. (I can't remember how they are made)