Quote:
Originally posted by Fixittt
Your going to rant about the block?
When you put the top on, did you slowly tighen it down like you would when mouning a waterblock? Cross corner?
|
no, no, no Fixitt. i wouldn't rant about this block. i was going to rant about how i had to go through almost hell to get it working (all coincidental) and when i finally get to use it, I freakin cracked the top. i think it's my fault, overtightening. am i supposed to tighten springs all the way down? or just partly?
when i mounted it, yes it was slow cross corner tightening. but i did tighten the springs dtek gives all the way down though.
again, Fixitt, i love this block. it is my most prized possession in my system. problem is, just when i am about to get it going, something major happens, and i can't. that's why my little post about selling it, i don't know if i have the balls to put it in now, but i most likely will, shoot, i waited almost two months for it! btw fixitt, i sent you an email.
decoded, i don't think it is a leak, but how can i be sure? if you saw how my dubro was, you could see that the water entering into the res is so strong, it hits the back wall, and creates this crazy ass whirlpool looking thing. i have the inlet of the res halfway up, and the current is so strong on the back wall, the water rushes all the way to the top, and topples over like a wave. that's why i think it is the res/flow. if it is an air leak, how can i tell for sure?
deez