View Single Post
Unread 03-09-2005, 07:57 AM   #58
Hoot
Cooling Neophyte
 
Join Date: Dec 2002
Location: Twin Cities
Posts: 67
Default

Well, the AS5 has had time to settle and still no joy. At load I'm seeing 22C water yielding 43-44C die temperature, which is still in the same range as the other three blocks. I'm starting to suspect that using an ambient system, it's going to be hard to break through that 22C differential barrier. I'm burned out on this block. About the only thing left to try, at a lot of effort, is to pull the NB and GPU blocks out of the loop, running the 1250 to the CPU block only. My gut feeling is that this is not a flow issue. I sincerely feel that I'm down to the source impedance of the high power-density core and the series resistance of the TIM being the limiting factors. I can't stress enough that "this is not your fathers Tbred" we're talking about.

Hoot
__________________
DFI LP UT NF4 Ultra-D 7.04-3 Bios
A64 3700+ San Diego 11x257 (2827 Mhz) @ 1.57Vcore
2x1Gb Crucial Ballistix 7:6 (300 Mhz) 3-3-3-8-1T @ 2.77V
Connect 3D x850xt 620/625
2x WD 36GB Raptors in Raid0
DIY Jet Impingement WB on CPU / Pipecap WB on GPU
Shrouded Camaro Heater Core / Swiftech MCP655 Pump
Antec P-160 Tower / Seasonic S12 600W PSU
MAXIM 6658 Thermal Diode Reader
Moderator at OCForums
Hoot is offline   Reply With Quote