Hmmm.... out of a batch of 10 reservoirs, where 2022 has been used to bond acrylic to anodised aluminium, one leaked but only when pressure applied via pump (Dual CSP750 - they were to hand) in a closed loop scenario. Assuming bad application of 2022 on that res.
Rigidty etc... can throw these as hard as you like against the nearest brick wall and the endcaps will NOT detach from the acrylic. Just dents the endcaps.
Currently knocking up a pressure-testing setup... any recommendations on a PSI to test up to? Have various old vacpumps and compressors here...
|