Pro/Forums - View Single Post

Redken · 03-10-2005, 12:01 PM

I found this very good article here. Maybe it will help somebody else too.

But I still have a doubt after reading the article.
According to the article I should rig my PS's in series to get 18v. But I would have to disconnect the ground of one of the PS in order to get it to work. Would that affect the rest of the devices connected to that particular PS?

For example, I have one of the PS hooked up to the MOBO and VID card. If I disconnect the ground on that one, will it affect the MOBO and VID?

The author of the article doesn't specify if he used his modded PS's as stand alone units for TEC use only or if he used it for the rest of his system also.

03-10-2005, 12:01 PM	#4
Redken Cooling Neophyte Join Date: Feb 2004 Location: Puerto Rico Posts: 15	I found this very good article here. Maybe it will help somebody else too. But I still have a doubt after reading the article. According to the article I should rig my PS's in series to get 18v. But I would have to disconnect the ground of one of the PS in order to get it to work. Would that affect the rest of the devices connected to that particular PS? For example, I have one of the PS hooked up to the MOBO and VID card. If I disconnect the ground on that one, will it affect the MOBO and VID? The author of the article doesn't specify if he used his modded PS's as stand alone units for TEC use only or if he used it for the rest of his system also. __________________ P4C800E DL,P4 2.4c @ 3.4(droop mod),1G Mushkin 3500 II 2,2,2,8 @ 3.1v,AIW 9800 Pro (450/370 @ 1.9v core),Audiology Platinum,2xDiamonds 8mb Raid0,Lian-Li Pc70,PC P & Cooling 510D,Plextor 708A,Plextor 52x32x52...water cooled...