Pro/Forums - View Single Post - Fillport placement

Twill · 03-12-2005, 04:56 PM

I should probably tell you the parts to help you think through:

Swiftech MCW6000
Undecided chipset block (probably will be old and cheap) which will change to a GPU block when I can afford a GPU

DDC
BIP II
Danger Den Fillport
lots of tight turns...hopefully no elbows

It;s all going to be 3/8ths although I may go to 1/2 by the fillport to slow things down a tiny bit, but it depends on how hard that ends up being.

it doesnt sound like it's going to be too much of a problem as long as I get the system well bled. Am I right?

Any other thoughts?

thanks

Twill

03-12-2005, 04:56 PM	#4
Twill Cooling Neophyte Join Date: Sep 2004 Location: la la land Posts: 27	I should probably tell you the parts to help you think through: Swiftech MCW6000 Undecided chipset block (probably will be old and cheap) which will change to a GPU block when I can afford a GPU DDC BIP II Danger Den Fillport lots of tight turns...hopefully no elbows It;s all going to be 3/8ths although I may go to 1/2 by the fillport to slow things down a tiny bit, but it depends on how hard that ends up being. it doesnt sound like it's going to be too much of a problem as long as I get the system well bled. Am I right? Any other thoughts? thanks Twill