Quote:
Originally posted by Fixittt
U know, I had that smae problem with my intercooler setup. Had air in the system. I used the fill tube to fill it, and had to turn the case upside down, and to the left and every other which way...... Then I relized that I had plugged the fill tube. This kept it an air tight system, I removed the plug on the fill tube, and within a few hours had all the air out of the system. Is yours sealed? if so, maybe a small pin hole up top somewhere will allow any built up preassure to be released.
Just my 2 cents.
Also, I will get you a now top. No problem. what size hose barbs did U have?
|
thanks Fixitt. yeah, i can't believe i finally got the system up, and i freakin crack the top, and must use a maze2 for now. i can't wait for the top, i will install that sucker immediately. i do have to contact danny though, and get one bolt for the mount. it seems my bag only had 3, i might have lost it, or never got it. and the funny thing is - NOBODY carries #8/32 x 2 1/2". can you believe that? jesus, that is one thing that got in my way, hence my comment earlier about the rant.
for everyone else, i solved the problem. it was the damn dubro. i am almost positive. i went out and bought a T fitting, and hooked it up. after less than 2 hours all air is gone. might be some bubbles, but i cannot see them. everything is fine and dandy here, yeah.
also, anyone have an Epox board? how accurate is the Thermistor? on MBM5 i have 22 ambient, and 35 CPU under load. that doesn't look to great to me. but i have a compunurse, and a thermometer next to me, they say 25 ambient and 28 load. what do you guys think? it is 8K7A with a 1.0ghz on it.
deez