Quote:
|
Really good stuff. Much easier to work with than 1/2" ID tubing, slips over 1/2" OD fittings as noted, bends tighter radii without kinking and with MUCH less effort, does not sacrifice flow-rates if using less than 3 metere of it when slipped over 1/2" OD barbs, and is slimmer and neater looking.
|
...Hard to believe that I could reduce the tubing size and not take a hit in flow rates. If Cath says so, though, I'll take it as gospel.
Any chance the 1/2" tygon would fit over 3/4" fittings? Would this help flow rates if coupled with an appropriate pump (a mag 5 or an Iwaki 20RLT off the top of my head). :shrug: :shrug: :shrug: