I tend to have a fixed piping method to make bleeding easier. Pipe the whole system so that when you lay the case on it's side as tho you were gonna work on mobo side, all inlets are at bottom and outlets are at top on anything mounted on front or rear panels... except your res. Inlet at top outlet at bottom.
Fill water system as full as possible with pump off, once it's as full as u can get it, cycle pump, keep filling. Once done, switch pump off, lay the lot on it's side and most items will selfbleed round to res... cycle pump a few times. Done. Should be fully bled within 15 minutes tops from start to finish.
|