I started out with a YY-Cube, thinking it would have been big enough for 1/2 inch tubing, but it really needs a couple more inches in girth in all directions. I was thinking about transferring the whole thing into a mountain mods UFO-2 aluminum case.
The end result ain't flashy, but it works as intended and nothing is smoking that shouldn't be. I know, the T-line is too long, and the loop is a little loose...
On the drive bay side, my super radiator duct sits.
There's two Panaflo 120mm fans running at 7 volts on the duct (push/pull). The rear and front of the duct are almuinum, and the "plenum" in the middle is made of cardboard laminated with aluminum tape.
The drain line was a major mistake. The side of the case is just shy of closing all the way. Live and learn...
When/if I get a mountain mod case, I'll fix it.
You can't tell, but there's Purple Ice in the water. I didn't know how much I needed, but I have a lot left, so I'll probably add more when I change cases.