Quote:
|
Originally Posted by JFettig
Madhacker, theres a huge problem with your design, that being how you will make it. There is virtually no way you can drill holes that close together, the drill will wander into another hole and probably break on its way in. You have to drill them far enough apart so they nearly touch but not closer.
Jon
|
Each 1/2" hole is 1/4" appart...
I was planning to start drilling all the holes(that aren't over the GPU)with 1/4" bit then go to a larger size untill I reach 1/2"
Since I have never done this before I'm hopeing this will work...
Worst case I can drill all the holes by 1/4" then ever second hole by 1/2" and use my dremmel to remove the excess...
I'm not planning to do any drilling on it yet untill I get some feedback from you guys, the pros who have done this before......
If you think the holes are to close together how far apart should they be?