Pro/Forums - View Single Post

futRtrubL · 01-12-2002, 11:04 PM

I think you have two problems, well one problem, which has been talked about, and one bug.
The problem is the voltage drop on the PSUs, this can be fixed with better rated PSUs.
The bug is board not using the on chip temp sensor. If the mobo sensor is on the pcb them it is covered with conformal coating as you said. This would insulate it from the CPU and so your readings would be closer to ambient than expected. You said that insulation wasn't complete, if that's still the case try touching the cold plate.

Edward

01-12-2002, 11:04 PM	#23
futRtrubL Cooling Savant Join Date: Jul 2001 Location: Kingston, Jamaica Posts: 204	I think you have two problems, well one problem, which has been talked about, and one bug. The problem is the voltage drop on the PSUs, this can be fixed with better rated PSUs. The bug is board not using the on chip temp sensor. If the mobo sensor is on the pcb them it is covered with conformal coating as you said. This would insulate it from the CPU and so your readings would be closer to ambient than expected. You said that insulation wasn't complete, if that's still the case try touching the cold plate. Edward Last edited by futRtrubL; 01-13-2002 at 02:57 PM.