^ looks like the black and silver look good with your computer and desk colors.
Be sure to check for leaks, some people have reported a leak out the open bolt hole right near the outlet fitting. This would be on the back side.
So far just been NPT fittings, and you just need to screw the fitting in another 1/4-1/2 turn.
The threads are cutting into the bolt hole, and not sealing proper.
This was my fault as the operator used my program to cut first run. On the drawings and sample I sent to AVT, the hole was not all the way through.
We only had one small run with this issue, if you have any problems just email me and I'll send you a new chamber half.
We leak test all pumps, but this problem only happens when you do the final fitting screw down, and does not show up on line test.
I tested all of D-Teks other shipment and could not reproduce the problem with there fittings.
* Note this is not an endorsement of C-System supporting D-Tek products.
Just letting everyone know of any issue we find.
**Delrin case NPT only so far, no AL case problems reported.
|