Hi.
If you refer to the components of the sensor, is not very important, these only they have condensers as filters, for sensor and Vcc regulator. The Vout of sensor go directly to the ADC.
If you refer to the components of the complete system, all the channels for pressure, flow or temperatures, they can be calibrated for a linear or not linear response by sofware. Also it is possible to calculate other parameters in real time, for example, sums, subtractions of channel, convert different units, calculations between different channels, for example to calculate the power lost or generated in W with a channel of flow and differential pressure, heat in w in the water (unsuccessful experience) velocity of the water, and other things that they can imagine and that the program supports, frecuencymeter to measure the sensor flow, measurement of the value every msec.
For example, the magnetic field of the punp without amplification y detected here.
Before testing, I calibrate sensors of pressure to 0. Normally when I begin the measurement´s of pressure, I can read approximately 0.002-5 mh2O out of scale
Later, I trust in the precision and lineality of the sensor and I have used a column gauge to compare the results.
On the beginning of the system, still I am verifying, it is possible to see information
here, sorry in Spanish.
One question please. ¿Where can I see a pressure drop vs flow graph of a MCW6002A?