Quote:
|
Originally Posted by Risky
The key thing for a flow meter is getting a tach signal bach to the motherboard. It you're looking for binary LED output then really a flow switch is the way to go.
|
Perhaps have a addon modual?
A seperate device that could plug into the the output of the flow meter that could determin a setpoint in rpm?
this could easily be made by someone with electronics experience...
Quote:
|
Originally Posted by samcat
What about interfacing with MBM??? As mbm has full plugin support, and LCDC (and many others) support reading MBM sensor readings...
Just a thought!
Cya,
Sam C
|
if it plugs into a MB header then all that would be needed would be a devisor.
MB monitor could read that easily enough.
if a USB solution is to be used...
I have done some interface programming with FTDI chips
linky
and is quite simple to implement.. don't know about the electronics side...