[tong]

Here's my problem and i've been searching all over the forum to no avail. I have in my posesion a mcw5000A and a MCW6000A (yes i know that the title says the 2A). My question is acording to the graph the 6000 is obviously a better producer, but if my thinking is correct the tests were done with the 5000 with the original 3/8OD fittings. If that's correct how do these 2 block compare if the 5000 uses 1/2 id barbs (basicly making it a 5002A)? The reviewer in the front used the 3/8th version for the review comparing it against 1/2" ID blocks, therefore it's not a very comparitive test.

Furthermore if my assumption is correct and the quick connect fittings were used that means that it's 3/8" OD pipe instead of ID making it even worste of a comparison. Can anyone test them on a 1/2 id loop and compare?