Quote:
|
Originally Posted by 2kcrewcab
OK...another question.....
I used the Knoppix method to get the sbin1000.bin loaded on a 30 GB hard drive on my Snap 1000 just to make sure I knew what I was doing. After loading it, SnapAssist could find the server, and give me the option to login. Since I didn't know what the Administrator password was set to, I did a manual reset to clear the settings. SnapAssist then gave me the option to setup the server....which I did with success..... 
So now, the goal was to upgrade the HD to a 120 that I just had laying around. It's a Maxtor ATA133 120 GB. I read a couple of posts out here where people are having trouble with those, but I'm not sure if I'm seeing the same problems or not....
Using the same Knoppix method that worked on the 30 GB drive, I was able to get the image installed onto the 120GB drive. I put it in the Snap Server and powered it up. It comes up and Snap Assist can see it. Just like before, since I don't know the Administrator password, I performed the same type of manual reset. Now when the server reboots, the system light blinks twice a second the Disk light stays on solid, and Snap Assist can no longer see the server.
Am I doing something wrong? :shrug:
Any help would be greatly appreciated!!!!!
Thanks,
Mike W. |
I did pretty much the same thing with my Snap 2000... I upgraded to the os v4 and rebooted... shortly after that, my The System light flashes several times a second, the link light is solid and the Net light flashes occassionally... At this point, it appears as though the server is initializing, but this has been going on for a long time... Just performed the upgrade on another server yesterday and *poof* wouldn't you know it... Destroyed another server... At least, that is what it looks like... Let me know if you come across anything to resurrect your server, and I will do likewise....