Side or top of case is pretty much out of the question. I selected this case as i love the layout, the quality of build, relative size, and twin 120mm fans. I had considered the PC series but after looking at Marci's mounting of a 160 i decided that it was too tight.
I also want the case to look as close as possibe to the original i.e. i dont really like holes in the top or sides etc. Silence is a priority hence why i have gone for the single PA160.
Any comments on mounting the pump upside down?
Thanks
Edit: Ignore question about pump as you beat me too it!
I was hoping to have the outlet go straight down into the rad and then out to the water block etc. Then i need to think about were to attach the T-Piece and the fill port....