Pro/Forums - View Single Post

TbirdX · 06-07-2005, 06:11 PM

I'm just about to swop from an Socket A TDX to an A64 TDX by switching the tops. I have the mounting hardware for the Soc A version but I just want to check a couple of things.

From looking at websites etc, I assume I need to remove the plastic socket around the CPU but retain the backplate to screw the studs into. Is that correct?

Also, for an Soc A you screw the brass thumbscrews down until the spring is compressed to 10mm, is that the same for the A64 TDX?

Cheers
T

06-07-2005, 06:11 PM	#1
TbirdX Cooling Neophyte Join Date: Feb 2005 Location: England Posts: 28	TDX Socket A to A64 Conversion I'm just about to swop from an Socket A TDX to an A64 TDX by switching the tops. I have the mounting hardware for the Soc A version but I just want to check a couple of things. From looking at websites etc, I assume I need to remove the plastic socket around the CPU but retain the backplate to screw the studs into. Is that correct? Also, for an Soc A you screw the brass thumbscrews down until the spring is compressed to 10mm, is that the same for the A64 TDX? Cheers T __________________ War will not determine who is right, however, it will determine who is left.