Quote:
|
Originally Posted by Risky
Just wondering if you would want to invert the PA160 and mount the fan externally below the case (I can't judge if those rather small wheels offer enough clearance, buy you could use bigger castors).
|
I considered that but id rather have it pulling cold air up through the rad.
Thanks for all the suggestions! I like the notion of having fans in the sides pulling air out but i really dont want to chop up this lovely case's exterior (Well, maybe to add a small window!
). I think i will mount it as it is, cutting a large hole above the fan, in the divider, so that air can be pulled up towards the drive bays (where i will mount the pump also). Then the air will be drawn out via the rear 120mm fan. Nice and simple and still keeping the shroud.
It makes the loop much easier too. I have turned the output to the side on the pump so i can have the T-peice there and then it goes striaght down to the rad and up from the front through the hole for the power cables and up to the water block. Then over to the GFX and back to the pump.
Now all i need to do is wait for the mobo that i want to come out - either a new Crossfire one or the 939/AGP that DFI will have out in a week or so.