Quote:
|
Originally Posted by Marci
Try ordering from one of the UK sites - should work out about the same price anyway afaik...
|
Finally
Between you and Cathar (G5 -soon) and my Papst 150mm (5v/ 100cfm and QUIET)
Present system w/ BIX + Panaflo M + cascade and stuff = 32-33 under load w/ x800xl in loop. I wonder how far below ambient I can get w/ the new stuff (J/K).
For some stuff of relevence to teh subject (since I've been through pretty much same senario
1. DON'T ATTACH PUMP TO CASE!! I got a big resonance effect that way (and mine is only an mcp350) Get a piece of sorbothane and /or a gel heel pad and put it on there.
2. Get tee so ID is at least same size as tube ID & if you can, one size larger. Heat gun and vaseline
will make getting the tubing on easy, then pull it off after it cools and clean up, then clamp as usual. Place it after the GPU back to pump. Higher/more horizontal is better (air bleeds out faster).
3.
Get one of these to place above your tee for easy filling w and short piece of tube attached above. Just stick funnel in & fill, then close and remove funnel
4. Coolsleeves are your friend when making the loop from CPU ->GPU etc.