Pro/Forums - View Single Post

WebMasta33 · 01-15-2002, 12:09 AM

Danner 3.

Since the inlet is 5/8", and the outlet is 7/16" ID x 3/4" OD, I was just gonna drill out the outlet to 5/8". I mean... Why not?

I mean heck, even when you get 1/2" barbs, you're still not getting a 1/2" hole. With my 5/8" barbs, you only get a 15/32" inside diameter hole. I mean yeah, it's 1/32" less than 1/2", but it's still not a half inch

*sob*

This was as big as I figured you could really go... Mainly because I'd have to pipe the tubing, and I just wanna use barbs and flexable 5/8" ID tubing. I am using nylon reinforced tubing though, to give it rigidity and not kink as much.

01-15-2002, 12:09 AM	#7
WebMasta33 Cooling Savant Join Date: Dec 2001 Location: Nebraska Posts: 526	Danner 3. Since the inlet is 5/8", and the outlet is 7/16" ID x 3/4" OD, I was just gonna drill out the outlet to 5/8". I mean... Why not? I mean heck, even when you get 1/2" barbs, you're still not getting a 1/2" hole. With my 5/8" barbs, you only get a 15/32" inside diameter hole. I mean yeah, it's 1/32" less than 1/2", but it's still not a half inch sob This was as big as I figured you could really go... Mainly because I'd have to pipe the tubing, and I just wanna use barbs and flexable 5/8" ID tubing. I am using nylon reinforced tubing though, to give it rigidity and not kink as much. __________________ ========== --Soyo KT333 DRAGON Ultra (Platinum Edition) --AMD 1.4 @ 1.54 (11x) --768mb of PC2100 (@140FSB) --Asus v8200 GeForce3 @ 210/490 --Maxtor 40gb Quiet + 2 IBM 40gb 60GXPs (removable) + 8gb WD --Audigy --Maze 3, DD Gf3 block, 2x BIX, Eheim1250 =========== Last edited by WebMasta33; 01-15-2002 at 12:15 AM.