[Techguy]

Originally posted by WebMasta33
Danner 3.

Since the inlet is 5/8", and the outlet is 7/16" ID x 3/4" OD, I was just gonna drill out the outlet to 5/8". I mean... Why not?

I mean heck, even when you get 1/2" barbs, you're still not getting a 1/2" hole. With my 5/8" barbs, you only get a 15/32" inside diameter hole. I mean yeah, it's 1/32" less than 1/2", but it's still not a half inch *sob*

This was as big as I figured you could really go... Mainly because I'd have to pipe the tubing, and I just wanna use barbs and flexable 5/8" ID tubing. I am using nylon reinforced tubing though, to give it rigidity and not kink as much.

Ack! That nylon reinforced shit is STIFF and it curls madly (cuz it's on that coil 4ever). You may want to use Silicon tubing.
Get it at http://www.mcmaster.com/