Pro/Forums - View Single Post - CSP-MAG available

Dave · 06-19-2005, 02:11 PM

"This indicates that load (backpressure) will not cause any issue to motor or electronics"

You are correct.

Is MAG enough for micro channel?
I measure 5.87 L/M using single MAG at 12.5V, 1/2 tubing on a Danger Den TDX block, 5.30 L/M at 12V

Just checked again since Lee's numbers seemed a little low.

I am surprised how much difference 0.5V makes.

Cather has a MAG OTW, lets see what his numbers say.
I believe he was going to test up to 14V, which is ok with us.

06-19-2005, 02:11 PM	#116
Dave Cooling Savant Join Date: Oct 2004 Location: Canada Posts: 260	"This indicates that load (backpressure) will not cause any issue to motor or electronics" You are correct. Is MAG enough for micro channel? I measure 5.87 L/M using single MAG at 12.5V, 1/2 tubing on a Danger Den TDX block, 5.30 L/M at 12V Just checked again since Lee's numbers seemed a little low. I am surprised how much difference 0.5V makes. Cather has a MAG OTW, lets see what his numbers say. I believe he was going to test up to 14V, which is ok with us. Last edited by Dave; 06-19-2005 at 02:48 PM.