Quote:
|
Originally Posted by kaotic504
that should be more than enough flow. there's a picture of someone w/ a loop similar to that on the forum. you're missing a reservoir or T-line in your loop.
|
I think you missed the end of my post
Quote:
|
I will be using a T-line , no more reservoir for me; thanks God
|
I think ~5lpm is good enough Dave, my old system had around that, 4-5 l/m.
My old setup was:
Hydor L30 -- DD Maze3 -- DD RadeonBlock -- DD Zchipset -- DD BayRes(the old one with no divider inside) -- Chevy 6x6 Heatercore -- L30
.... and around 9.5 feets of Clearflex60 ½"
Thanks for your reply guys, I will probably set it up over the next week... Im still waiting for the GPU wb
+ a few questions I'm asking myself like:
-Am I better to mount the heatercore with the in/out ports at the bottom or at cpu level?
-Should I use PVC ½ fittings on the pump or brass ones? The brass one can be cleaned and enlarge a bit to make them more +½". My rad got the brass ones with enlarged opening
-With impingements wb like the TDX, I guess I would see better performance if it's straight after the pump, followed by the Maze4GPU than pump-gpu-tdx-rad... right?
-Also got the Nozzle accelerator kit with the TDX... Many reported better performance with #4 in single block application, not sure about dual blocks tho...
-As for the heatercore, I still don't know if Im going to Push-pull(4fans) or pull only(2 fans). I made 2 shrouds anyway. Many told push/pull was a waste of time, tho I always got 2-3C less in push/pull on my old HCore than pulling only.... Pushing is even worst :shrug:
-What's the best place to put the T-Line? Between the radiator and pump inlet, at the highest point ,after last waterblock just before the radiator? So many locations.... :shrug:
Will post pics when I'll be done over the next week... too bad CanadaPost ain't delivering tomorrow
Still on planning....