Update:
Cutting to make room for the rad's fan:
Cut finished and c-strip added to the egdes:
Testing the positioning of the rad and fan:
note: That will be a PAPST (AKASA one is going to replace a case fan
)
Rad complete for installation:
I had some spare foam from the bottom of the rad so i added it around the shroud to make it airtight.
Added a bit of duck tape to the bottom to hide nasty rough edges:
This is how i placed the pump and routed the outlet straight down to the rad:
The pump and T-piece that is going to be connected to a DD fillport (awaiting more jubilee clips to finish this!). You can also see the rad outlet coming up.
And the two water blocks (that is a polarflo TT for the gfx) with heatshrink over the jubilee clips:
Question: How much of a difference will blowing out have than pulling air in? I am still worried about dust.
Thanks!
Next update tomorrow probably.