View Single Post
Unread 07-27-2005, 09:28 PM   #681
blue68f100
Thermophile
 
blue68f100's Avatar
 
Join Date: Jul 2005
Location: Plano, TX
Posts: 3,135
Default BIOS Recovery Snap 2000

Has anyone figured how to recovery when the server will not connect to the lan. I had an upgrade go south. The unit powers up, access disk, but no NET light.

Looking over the Mother Board I found a RS232 Serial Port header. Has any one tested this port. Chip MAX241CAT.

There is also a Floppy Disk Controller on board to, SMC FDC37C669QF P.

On the 2000 I think that the software is loaded in to the AM29F800BT , boot sector flash memory.

There are also to jumpers on the board, JP1 and JP6, has any one figured out what these are used for? Reset ? Forced Disk Boot? Load software from disk?

Blue68F100

Last edited by blue68f100; 07-30-2005 at 07:09 PM. Reason: Serial Port found on MB
blue68f100 is offline   Reply With Quote