Quote:
Originally Posted by blue68f100
Has anyone figured how to recovery when the server will not connect to the lan. I had an upgrade go south. The unit powers up, access disk, but no NET light.
Blue68F100
|
I had that happen, I just used the hard reset, where you get into a reset mode. This is quoted from their manual
To reset the server settings:
1 Turn the Snap Server off (as described on page 7) and
wait for all of the lights to turn off.
2 Press and hold down the Reset button. While you are
still pressing Reset, turn the Snap Server back on; wait
until both the System and Disk lights start flashing in
sync. (To press the Reset button, push a pencil point or
similar object into the reset button.)
3 Release the Reset button.
4 To select the settings you want to clear and reset, briefly
press the Reset button:
Once to clear the server's IP address.
Twice to clear the Administrator password.
Three times to clear the server's network settings.
Four times to clear all system settings.
5 Watch the Disk light and verify that the number of times
it flashes corresponds to the number of times you
pressed the Reset button. For example, if you pressed
Reset three times to clear the network settings, the
Disk light should flash three times repeatedly to
confirm the reset. If the number of flashes exceeds the
number you intended, repeat steps 4 and 5 of this
procedure.
6 When the light confirms the level of reset you intended,
press and hold down the Reset button until both the
System and Disk lights turn off, and then release the
Reset button. The server then restarts, and resets the
settings you cleared to the factory defaults.
If you have already tried that then I don't know.