I've had about 3 setups and some switching of WC system
Knocked off vid card resistor chip with hard nylon washer when tighten the block down. Lets just say there wasn't enough clearance and had washers on top of two resistor.
I glued one resistor back on and card worked!!! I ditched the mount on that side.
Then a second resistor got crushed slowly with time and the card failed.
Only way I could see that block working is with a huge rubber washer over nylon washer.
Had a mcw5000 not properly mounted on my athlon xp and had a huge gap. THe cpu shutdown was on so i was okay till I fgured out the problem.
Another time had a L30 shaft break on me. Noticed high CPU temps and I had to shake pump to get it started.
|