Okay. The bottomm piece is 5/8", so the jet will be 5/8". However, the barb going in will be about 1/2" (slightly less). You might be right, since the jet will be 5/8"... I could cut the total size down to 1/2", but I'd lose one channel.. would 6 channels still be decent?
I also have a few other general question, some have to do with the waterblock, some with general watercooling, so I'll post them all here and all at the other site, and see which answers I can get.
1. Right now I'm looking at some threaded fittings. They fit into my design quite well, but they're only 3/8" ID because they're intended for high pressure, but I can bore out the inside of them to be almost exactly 1/2", since there'll be almost no pressure in my system. The only problem is that if I bore them out, it exposes the plain aluminum (since they're anodized or whatever). Would that be alright (since it's only on the inside, or should I keep it at 3/8" or not use 'em all? Also, if I do bore them out, should I do that only to the middle one, since you can't put double the volume out than in anyway?
2. Is glycol alright to use as corrosive inhibitor?
3. Can I make the top 2 pieces of my waterblock (that are not used for transferring heat) out of aluminum, as long as I protect the outside from corrosion? Would it be a problem on the inside? I don't see why, considering my dad's truck has an all aluminum heatercore, and it's perfectly clean (Glycol in the system).
4. Also on aluminum, does tubing made out of it work? I could get some thin-walled stuff that would work pretty good... again on the corrosion.
5. Do I have to make a backplate for my waterblock (To mount on motherboard)?
I'll edit this post if I have any more questions!
|