Quote:
|
thats how it is configured (on a separate lead), need to add a photo showing the connector
|
Forgot to add into that the MCP655 / D5... as you're the man in the know when it comes to Laing's products have they been poked to add to that model as well? Would be the icing on the cake for the D5, and was amazed they didn't put it on there already...
Anyways, simple solution to the above 3pin header argument is, supply the pump with Molex and RPM connector, and 2x spare pins for the RPM header so u can snip and solder them on and convert it to 3pin should the end user so desire... just means dropping the remaining pins into the box...
As imo if a customer can't solder two bits of wire together then they shouldn't own a waterkit (just on a basis of iq level / ability - badly phrased but can't think of right phrase)...
Or a simple adapter to accept molex and 3pin with rpm only and convert down to single 3pin...? Add into paperwork a "use at own risk" statement covering why it isn't like that to start with...