In all the tests above using the MCP 350 was the 3/8" fittings and tube used also the 3/8" barbs on the Storm G4 as that is what I am using at the moment and I'm looking to see if it is worth me going to 1/2" what is the likely improvement by going to 1/2"?
And then this is a noob question, the reservior I'm using is the Tank-O-Matic External Reservoir, the fittings are about 3/8" so if I were to mod the pump leaving the output @3/8" and the inlet to 1/2" wouldn't that make a flow restriction?
What I don't understand is why are the reserviors made with such small bore's? am I missing something?
|