To get greater ventilation I felt that this marked area was what needed removal
just under that place on the case is where I will be mounting a fan to draw a
little more air inside the case. I drew the lines using a little genuine ghetto
technology (old leftover coppercap & a stick!
)
Using my Dremel, I cut away the vent hole for the fan. After seeing what I did,
I kind of liked how this was going to turn out. The next step was to fill in all
the holes used for the power and reset (and I think a Turbo switch) well, all
except one. I have no pictures of when I used bondo on those areas, I was going
to be late for work (again!) and had no time to take pictures.
after a lot of sanding and cleanup, I size a small piece of my favorite modding mesh
to fit the opening. Then Tacked it down temporarily with Hot Glue.
mesh being sized up...
after tacking with the glue...
a look from the front...
