Quote:
|
Originally Posted by blue68f100
The reset should be like all of the Snap servers (1000,1100,2000,2200).
Press and hold the reset button while powering up the unit.
Press the reset button 4 times.
The disk light should blink 4 times.
if not push the reset button to correct.
If correct 4 blinks
Press and hold the reset button till the system light and disk light goes out.
release the reset button
The unit should reset all network settings and the Admin Password.
Wait at least 2 minutes.
Then use Assist to do the initial setup.
Good luck
David
|
Thank you for your help.
Unfortunaltly, as i mentionned before, this procedure does't work. When I try to do that, disk 1 blink, blink 2 blink and...power off. I do not understand why. It seems so simple to reset the unit, but not for me