Quote:
|
Originally Posted by killernoodle
That machining is incredible. What is the ID of those jets?
|
0.45mm
Quote:
|
Originally Posted by mwolfman
What’s the total production time (Silver and Delrin). I guess the Delrin manufacturing time is about three times the silver time?
|
Total production time is a shade under 3hrs all up (about 2.5hrs CNC work).
Silver CNC time is about bang on 1hr.
Quote:
|
Originally Posted by mwolfman
What’s the pressure drop? (IE that pump is required to run a G7 CPU AND G7 GPU block inline)
|
Measured to have a slightly lower pressure drop than my original Storm/G4's.
Quote:
|
Originally Posted by mwolfman
Do you have to machine (mill) the silver block (silver = soft and the pattern is relatively easy to press), what’s the depth on the hols, and diameter (in mm please) any angel (like a upside cone)?
|
I would say that the pattern in this block would be extremely difficult to press reliably. As for the other info, no comment.
Quote:
|
Originally Posted by mwolfman
What type of filter is needed so there aren’t any hold-ups in the jets? (I clean my system ones a week with air bubbles...)
|
Either ensure that your water & system is clean when you fill it, or alternately use a cheap micro-irrigation filter if you're really worried.
Quote:
|
Originally Posted by dacooltech
I especially loved the Wye connection integrated to the top plate... there are 2 holes in the mid plate too if i'm not mistaking... positioned above the center of the channels on the BP sucking coolant from the channels (some kind of Venturi effect perhaps? )
|
Correct on all accounts. I did my best to ensure that the block allowed as free flowing of an exit path for the water as possible, as well as eliminating any and all calls for a possible third barb.