View Single Post
Unread 10-01-2005, 12:43 PM   #8
dacooltech
Pro/Vendor
 
dacooltech's Avatar
 
Join Date: Feb 2002
Location: NYC
Posts: 267
Default

Quote:
Originally Posted by jaydee
Bah, I am reading the graphs wrong. For some reason I assumed he used the MP-05 SP with all 3 jets. Now I see he did the three blocks with their default nozzels....

I would have liked to see the MP-05 SP with all 3 nozzels done. I got the #1 much better than the #3 but more restrictive aswell.
The MP-05 Pro BP has 270pins and he tested it with N01 slit (which is the default mid plate for the Pro)... You tested the N01 nozzle with MP-05 SP BP with 300 pins.

Now one other thing is Robotech e-mailed me to give me the heads up on 2 things.

1) Springs that he received are on the light side for A-64 2x studs mounting

I found out that he was right, and the last batch of springs that we received were a bit different than what we normally use. Thanks to Lee, I took care of that one before sending them to the customers... but couldn't send him new set of springs before he completed the review.

2) He also e-mailed me that he measured the channels on the base plate at .015" wide (going the long way) and .012" wide (going the short way).


I know the exact reason for that, and that's my fault really. I rushed out the first samples, and unlike the production units, that small variation causes the samples that I sent him being more restrictive. I should be more careful, but a lesson learned...

I pretty much perfected things now, but there's still more work to do...

Edit: wording
__________________
www.cooltechnica.com

Last edited by dacooltech; 10-01-2005 at 10:38 PM.
dacooltech is offline   Reply With Quote