Quote:
|
Originally Posted by unregistered
fine jet alignment between pins requires locating pins
or the results will be different between EACH assembly of the wb pieces (clearance in the bolt holes)
the results for this wb, just like the Nexxos, will show larger than normal variations
not a good short cut if aiming for maximum consistent performance
- all about the target consumers (price/performance/understanding)
|
Alighment pins are good as long as the machining is accurate to begin with. It looks to me like the mill used on the MP-05's seems to not make a constant accurate move to the next channel. It could be in the coding, the mills controller or the mill itself (or all the above). Bruce says he has a handle on the problem though.
There seems to be plenty of room for a couple pins though.