Quote:
|
Originally Posted by Talonz
Hi, I was wondering if anyone (especially RoboTech or Jaydee) has results to compare between the three accelerator nozzles. I have a MP-05 pro coming in next week, so I would be really interested in which one performs the best. This will be my first setup, so I don't really want to test my luck too much by testing and fiddling around with the mid-plates
|
I recommend either N02 X or N03 Jets... N02 X nozzle works very good...
You'll get the best results with the N03 jets though...
If you're going to install the block in to an existing system, make sure to flush it first, and then refill it with distilled water + Zerex RSC @ 5-10%
Quote:
|
As already mentioned, I agree that the MP-05 Pro with the unaligned pins might be a problem. I know you guys have been working for quite a while on the review, but if there are any numbers or even theories on the best midplate (#1 or #2) for the MP-05 Pro, they would be greatly appreciated. I imagine that midplates 1 and 2 would provide a similar performance change between the 270 and 300 pin versions of the MP-05 block.
|
No worries... the production units are much better than the early review samples... The review samples were sent out in the early phase of the production... the prodcution BPs are also lapped flat with a Peter Wolters AC 500 lapping machine
The N01 mid plate works good with 270pins @ low flow... better with 300pins but it's more restrictive than 270 pins...