Quote:
|
Originally Posted by dacooltech
I recommend either N02 X or N03 Jets... N02 X nozzle works very good...
You'll get the best results with the N03 jets though...
If you're going to install the block in to an existing system, make sure to flush it first, and then refill it with distilled water + Zerex RSC @ 5-10%
No worries... the production units are much better than the early review samples... The review samples were sent out in the early phase of the production... the prodcution BPs are also lapped flat with a Peter Wolters AC 500 lapping machine
The N01 mid plate works good with 270pins @ low flow... better with 300pins but it's more restrictive than 270 pins...
|
Okay thanks, I think I'll give it a shot with the N02 X nozzle. I don't think the CSP-MAG I have coming in will give me better results with the N03 jet nozzle.
I guess the only things that are bothering me now are the results that jaydee posted between the N01 and N02 nozzles. Maybe the N01 nozzle performed exceptionally well on the 300pin version because the base was so restrictive?