View Single Post
Unread 10-05-2005, 11:17 AM   #11
stephen
Cooling Neophyte
 
Join Date: Oct 2005
Location: St. Louis, MO
Posts: 4
Default

Quote:
Originally Posted by blue68f100
Stephen,

The light is flashing because there is no drive. You will have to use the assist program to set the snap up on the network. Go to poogles_uk site and download the assist program. It will search on the network for thesnap and do the initial setup. If you have an old drive install it. Make sure the fan is running. If if fails you will fry the system board.
ftp://snap:snap@65.68.230.225

David
Thanks for the suggestions. I downloaded the Assist program and attempted to get it to recognize the Snap Server 2000. Alas no luck. I then looked closer at it and noticed that the System LED is exhibiting the continuous dimming/brightening pattern indicating "Failure Mode." I'm not sure where to go from here. Does this indicate that the motherboard is fried or should I try to replace the RAM and see if that is the culprit? And if the motherboard is fried, is there a way to replace it?

I appreciate any light you can shed on this.

Stephen
stephen is offline   Reply With Quote