Pro/Forums - View Single Post

Bigredhog · 10-15-2005, 02:46 PM

I'll plan to start in a pull configuration since the PA160 fins arent as dense and airlow is not as restricted. I would think by pulling and creating lower pressure within the shroud I would get air flowing more evenly over the entire radiator surface as opposed to pushing and having my airflow basically passing through the radiator in a smaller area of the radiators surface. As long as I can maintain the temps I have now Ill be content. At the moment Im getting 5 degrees above ambient at idle and 9-11 degrees under load according to MBM on a 4800X2.

10-15-2005, 02:46 PM	#5
Bigredhog Cooling Neophyte Join Date: Oct 2005 Location: Peoples republic of Kalifornia Posts: 16	I'll plan to start in a pull configuration since the PA160 fins arent as dense and airlow is not as restricted. I would think by pulling and creating lower pressure within the shroud I would get air flowing more evenly over the entire radiator surface as opposed to pushing and having my airflow basically passing through the radiator in a smaller area of the radiators surface. As long as I can maintain the temps I have now Ill be content. At the moment Im getting 5 degrees above ambient at idle and 9-11 degrees under load according to MBM on a 4800X2.