Dead 1000
David,
Thanks for the ongoing info.
I reset the server (four clicks). Loaded the orig disk and snap assist found the server once past the workstation firewall.
SnapAssist sees the server and reports the Details:
IP: 192.168.0.2
Software: 2.2.393
Hardware: 3.1.1
DHCP, BOOTP, RARP: No
SN: 108360
but cannot reach the server at that address. My local subnet is at a different address, so I don't think it is an address conflict.
In W2K Pro, the server is not seen. Ditto for XP.
The web browser cannot reach either the snapSN or listed IP address.
Will a new drive make it all good?
I'll get a 5400 ATA100 drive. How big can it be with the hacking resources of the group?
Thanks again,
Nelson
|