Quote:
|
Originally Posted by tritonx
I had the copper plate rotated 180 degrees so that the outbound head was not aligned to the copper indentation on the water block.
Now you've all got me interested, i will run some simple flow tests (not sure if it's of interest).. 1st will be lpm calc (Based on how fast it fills up 1L) with just reservoir to pump (6 inches distance) and second will be reservoir to pump to block (6 inches again)..
|
Height is important in your testing, Water going in at the same height (above the floor for instance) as the water coming out. That will eliminate pump head considerations in comparing your tests to each other. If the pump has to "lift" the water farther in one test vs another that will skew the results. A small point, but something to consider